Jigks
Full Access Member
This one @Yukon Joe.
---------- Post added at 08:43 PM ---------- Previous post was at 08:39 PM ----------
Hey @Fb73. Couple more photos of the compressor mounting.
Basically, I had a stainless steel plate off cut from work (essentially conveyor skirt wear liner mounts) which had countersunk bolts. I matched it with existing holes on the bumper mount, trimmed the plate to suit and mounted the compressor on that. So essentially the plate is mounted with two M12 screws. So no Raptor parts were harmed in the mounting of this compressor!
---------- Post added at 08:43 PM ---------- Previous post was at 08:39 PM ----------
Hey @Fb73. Couple more photos of the compressor mounting.
Basically, I had a stainless steel plate off cut from work (essentially conveyor skirt wear liner mounts) which had countersunk bolts. I matched it with existing holes on the bumper mount, trimmed the plate to suit and mounted the compressor on that. So essentially the plate is mounted with two M12 screws. So no Raptor parts were harmed in the mounting of this compressor!
Last edited: