What did u do to your raptor today?

[highpowernut]

Changed the oil and installed a Stahlbus Engine Oil Drain Plug

Did the same, also installed a yellow top optima.

 

[woutvc]

I installed a dual battery setup in the back of the truck.
Next step is installing 12V and USB plugs for a fridge and other stuff.

 

[RAPTURR]

Finally got the 37"s put on

Sent from my XT1585 using Tapatalk

 

[marcomilano77]

Weekend project. Fitted up some Boatec fenders and some much needed maintenance

Sent from my XT1585 using Tapatalk

Look awesome! What width are those Boatec?


Sent from my iPhone using Tapatalk

 

[cobrajet]

Cleaned it and gave it a once over to prepare for a trip to Wyoming / Colorado. Removed all the factory tape from the rockers, sprayed it with a little Amsoil MPHD and re-taped it. Though there have been other threads on the "holes" in the rockers and floor pans that are covered with nothing more than tape, I discovered another at the rear of the crew cab located just under the factor tool box under the rear seat and it appears it was never taped. I had water underneath the tool kit, so I corrected that problem as well. Little disappointed that Ford went so cheap.

 

[Ramathorn178]

After saying I would never drop the coin for center caps and you ***** being a bad influence on my wallet. Well at least I'm not the same as everyone with "svt" caps.

 

[Deleted member 12951]

After saying I would never drop the coin for center caps and you ***** being a bad influence on my wallet. Well at least I'm not the same as everyone with "svt" caps.

Is that the trojan ****** logo?

 

[Ramathorn178]

Spartan technically. Who the **** wears condoms?

 

[RAPTURR]

Look awesome! What width are those Boatec?


Sent from my iPhone using Tapatalk

+2

Sent from my XT1585 using Tapatalk

 

[NE Ford]

Meant to post this a while ago but bypassed the rear master harness with @t_j. Truck was previously in a front end collision where the harness was damaged and never replaced. Caused the truck to throw codes and stall frequently. Went wire by wire and no issues since.

Not ideal but works fine. It's quite an expensive part to replace!