GEN 1 Trans has no reverse or foward gears

[Blue442]

Can anyone give me any info on my 2010 Raptor. I rplaced the engine with a factory long block. It ran great for around 150 miles. While driving at 45mph the trans went out. There was no grinding clunking any type of breaking sound. I have no forward gears or reverse the only dtc is po735. Has anyone else had this problem

 

[Sernas]

Have you checked your transmission fluid level? Also might disconnect the battery and reset the ecm see if that helps.

 

[Blue442]

I cleared the po735 code with my scanner. Fluid level is good.

 

[1BAD454SSv2]

See if the bolts came out between fly wheel an torque converter or possibly transfer case not engaged , does truck lock in park or can you roll it? Your pump could of given up. Could be a solenoid you said it happened at 45mph that's right before it shifts to 6th gear.

 

[MEATSWORD]

+1 for converter bolts missing

 

[Blue442]

Yes bolts are tight locks into park. If I take it out of park it will roll. Its so weird loosing all gears and reverse. There was no slipping no type of noise at all it was like I put the trans in neutral. When I stopped put it in park started the truck put it in drive nothing pulled it down into lower gears nothing put it in reverse nothing.

 

[1BAD454SSv2]

I say pump , similar happen back in the day , my 1995 tahoe driving along then nothing , would'nt move pump gear in trans broke. Should be a port to hook a presure guage up to.

https://www.sonnax.com/tech_resourc...-ford-6r60-80-tc-related-drivability-concerns

 

[Blue442]

You are correct 1BAD454SSv2. Had put the gauge on earlier today. I pretty much knew it was the pump. I sure didnt want that to be the problem got on this forum wanting someone to say it was a drop the pan fix. Oh well cant have gravey n biscuts all the time. Thank you to all that replied.