SVC bump stop can problem

[SilverScrew_]

Hey everyone,

I just installed the svc bump stop kit with king bump stops however I’m not able to insert the bump stops into the cans. The Allen bolt does not align properly with the hole which stops the bumps from being inserted all the way and screwed down. Did anyone have this problem?
Thanks

 

[CoronaRaptor]

Did you get the adjustable bump stop kit for a Gen 1 or… I was trying to look at the install instructions online for you,

 

[SilverScrew_]

Yes adjustable bump stop kit for gen 1 with kings!

 

[SilverScrew_]

This is taken off svc website. But as shown, the Allen bolt is flush to the top. I was just wondering if it just took some force to get in. Videos I’ve seen online of inserting the bump stop into the can; it goes in smoothly

 

[CoronaRaptor]

Dude, just phone Jeff @svc and see if he can answer your question, I'm sure he will.

 

[BenBB]

Mine matched up perfectly but it's a Fox bump. I just found the instructions, like 20 pages, @SilverScrew_ want me to scan and email it or did you get ahold of Jeff? It doesn't say **** about that allen...

 

[svc]

There are times the King can be tight compared to the Fox. Easiest thing to Do if this happens is to slightly drill/dremal open if possible. Again not ideal but seems every so often it happens with the King bumps. Please email Me with any concerns or questions and I am happy to assist [email protected]

 

[Canuck714]

This is taken off svc website. But as shown, the Allen bolt is flush to the top. I was just wondering if it just took some force to get in. Videos I’ve seen online of inserting the bump stop into the can; it goes in smoothlyView attachment 312504

Just ream the hole out a bit.