SPD trombone & QTP E Cutout

[Chiefapple]

Eric, Here is a picture of the stock bolts and the bolts/nuts that come with the kit. Actually I wish the bolts that came with it had an extra 1/4” of thread. Couldn’t get it 100% tight but then again the SPD downpipes adapter on mine was slightly bent. I am taking off the trombone today so had a chance to do this for you, not that you are trying to hold me hostage for a picture, not sure what that is about. ‍

It was a joke, but that’s ok. A picture of nuts and bolts doesn’t help any. There is a reason when I purchase all my parts from Freedom Motorsports, I don’t reach out to you.

 

[Rick at FMS]

@Chiefapple Any bolts will work that fit, more for it you have aftermarket downpipes. You just have to connect the two and you would use the nut for the bolt you get. The ones they supply as shown are a course thread.

Thanks for your support of Freedom Motorsports. I know on a personal level the deal on those wheels didn’t pan out and I do apologize for that again.

 

[Rick at FMS]

It was a joke, but that’s ok. A picture of nuts and bolts doesn’t help any.

Went to the hardware store to help. It looks like a M10x1.5. 3” long with a shank of 1.75” and 1.25” of thread. Hope that helps. Oh and the rear hangers just need a deep socket 10mm. I also thought it made it easier during the install to remove muffer hanger that is in front of it, that is also a 10mm

 

[Chiefapple]

Went to the hardware store to help. It looks like a M10x1.5. 3” long with a shank of 1.75” and 1.25” of thread. Hope that helps. Oh and the rear hangers just need a deep socket 10mm. I also thought it made it easier during the install to remove muffer hanger that is in front of it, that is also a 10mm

Yeah. The tailpipe section isn’t coming free of the muffler section. I’ve about had enough and will let someone else do it. Rust is rust. I can fight through all the clamps or let the pros handle it.

 

[ShadyRaptor]

PM