RotorOver
Full Access Member
Installed the red backlit Radiance Scene reverse light kit from @Specialtyperformanceparts today. I'm super happy with the results! The weather pack connector set-up on the switch wires is brilliant allowing for all kinds of configurations with your switches and no need ever to cut any of the wires to reconfigure.
Got their Full Length Harness which routes from the rear lights to the switch wires for power/control and the Taillight Harness, which provides both reverse light and backlight power. I chose to run the reverse light power/control off of the switch only, but you could set it up to be powered automatically when put in reverse in addition to switch control. The backlight is powered by the Taillight Harness.
Took awhile to find and access the switch wires. Both sets were taped to a large wire bundle on the front side (side closest to the passenger side headlight) of the battery. The live wires were taped on top with a white and red tape holding them to the large wire bundle. I used the sharp end of a trim tool to pick away at the tape until it separated. The dead wires were underneath only a loop of it visible. They were secured in a bundle by a white piece of tape. I couldn't get a picture of them in place but here are some pics of the tape after removal and the exposed wires.
One difference on the 2021 Raptor was the small grounding bolt was removed, so I used a different one closer to the bumper and the large bumper ground. There are two identical bolts there, so I picked one of them.
A shot of the pair installed.
Got their Full Length Harness which routes from the rear lights to the switch wires for power/control and the Taillight Harness, which provides both reverse light and backlight power. I chose to run the reverse light power/control off of the switch only, but you could set it up to be powered automatically when put in reverse in addition to switch control. The backlight is powered by the Taillight Harness.
Took awhile to find and access the switch wires. Both sets were taped to a large wire bundle on the front side (side closest to the passenger side headlight) of the battery. The live wires were taped on top with a white and red tape holding them to the large wire bundle. I used the sharp end of a trim tool to pick away at the tape until it separated. The dead wires were underneath only a loop of it visible. They were secured in a bundle by a white piece of tape. I couldn't get a picture of them in place but here are some pics of the tape after removal and the exposed wires.
One difference on the 2021 Raptor was the small grounding bolt was removed, so I used a different one closer to the bumper and the large bumper ground. There are two identical bolts there, so I picked one of them.
A shot of the pair installed.
Last edited:
