Official Raptor R Modification Thread

[MultiStateRaptor Guy]

Nope, asphalt or cement. This is a quarter mile race: straight up.

Disclaimer: If you've installed any other type of a aftermarket supercharger, and created all that new horsepower after "our" agreement, your stock Raptor R, versus our mods on our 2023 Raptor V6 EcoBoost.

 

[MultiStateRaptor Guy]

Miss/ Mrs. Master/ Mr. Hard R,

All of those mods your talking have/ or will be done, including the "new" Stage 5 CR Turbo's.

 

[New recaros]

Miss/ Mrs. Master/ Mr. Hard R,

All of those mods your talking have/ or will be done, including the "new" Stage 5 CR Turbo's.

Hope it makes the quarter mile

 

[Hard R]

Miss/ Mrs. Master/ Mr. Hard R,

All of those mods your talking have/ or will be done, including the "new" Stage 5 CR Turbo's.

Too practical to do those kinds of mods. Stock Raptor here. I'm just looking for a play date in the desert.

Pull up.

 

[tmurk684]

Designed by Moran has a cooling upgrade kit available for the Rs. Might be a good addition if adding the 3.8. I found out about them from calling ADD to see if they were making a winch capable bumper for the R. He said DBM offered an intercooler relocation kit that allows for use with the Stealth Fighter winch kit and bumper. I didn’t see a relocation only kit on their site though.

 

[Hard R]

Designed by Moran has a cooling upgrade kit available for the Rs. Might be a good addition if adding the 3.8. I found out about them from calling ADD to see if they were making a winch capable bumper for the R. He said DBM offered an intercooler relocation kit that allows for use with the Stealth Fighter winch kit and bumper. I didn’t see a relocation only kit on their site though.

I spoke to DBM recently and this is what they said:

"This kit was primarily designed as a high clearance option for the people wanting to run a winch or frame cut bumper etc, performance wise you will see improvements with trans temp and improvement with the supercharger cooling system but If you are looking for just performance and don't plan on doing a winch or bumper we are a couple of weeks away from releasing our full performance package which will be a huge step up in cooling capacity and performance over OEM however this will not be compatible with a winch or frame cut bumper."

 

[Hard R]

Ancra Aircraft L-Track riveted to the bed
Aluminum: 6351

Double stud fitting:
Working load: 1666 lbs
Break strength: 5000 lbs

 

[Dudebrodude]

Ancra Aircraft L-Track riveted to the bed
Aluminum: 6351

Double stud fitting:
Working load: 1666 lbs
Break strength: 5000 lbs

View attachment 481184

Are they flush with the bed when you don’t have anchors in

 

[Hard R]

Are they flush with the bed when you don’t have anchors in

It is raised very slightly and not flushed.