OBDLink MX and DashCommand

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

ZBoater

FRF Addict
Joined
Mar 9, 2014
Posts
1,980
Reaction score
866

Attachments

  • image.jpg
    image.jpg
    15.7 KB · Views: 561

mike.s

Well-Known Member
Joined
May 12, 2012
Posts
974
Reaction score
639
I have this exact same setup. I love the compact size of the OBDLink MX. I'm still playing around with Dash Command to figure out all it's functions. One small problem I've had is the screen the shows fuel level. When I first fire up the app it works fine, but after a few minutes, the fuel level just goes blank.

Sent from my XT1080 using Tapatalk
 
OP
OP
ZBoater

ZBoater

FRF Addict
Joined
Mar 9, 2014
Posts
1,980
Reaction score
866
I just used the fuel level screen to empty my truck out of 87 octane gas so I could load up on 93. I ran it down until it said I had 2 gallons left. I pumped 35 gallons of gas. It was either off by a gallon or my 36 gallon tank holds 37...

Anyways, it would not reset after that. It took forever to recognize the new fuel. I force stopped the app, relaunched, and then it was fine. Hit the multi task button, then swipe the app to the side. That kills it. Relaunch it and see if it makes any difference.
 

Icecobra

FRF Addict
Joined
Oct 15, 2012
Posts
3,349
Reaction score
1,755
Location
Gilroy Garlic capital of the world
Ii found it funny the Torque pro app can not write to the ECU on the truck.. But I changed the number of gallons my tank could hold on the app and it wrote that info to the ECU... I had a quarter tank left put in 6 (I meant to put in 36) and **** it showed almost full of fuel on the fuel gauge... So it can obviously write to the ECU at least in some respects.. I changed it to 36 and the gauge went right back to little less than 1/4 tank... I have used Torque for more than two years and reset countless friends CEL and pulled trouble codes....
 
OP
OP
ZBoater

ZBoater

FRF Addict
Joined
Mar 9, 2014
Posts
1,980
Reaction score
866

Attachments

  • image.jpg
    image.jpg
    69.3 KB · Views: 84

MTF

FRF Addict
Joined
Nov 27, 2010
Posts
5,438
Reaction score
2,374
Location
Celebration, Florida
IceCobra,

I've had lengthy emails with Ian Hawkins (creator) with concerns to TorquePro damaging the Whipple/Ford Tune. TorquePro does not have the capability to write.

What you did is change how the information was being displayed.
 
Last edited:
OP
OP
ZBoater

ZBoater

FRF Addict
Joined
Mar 9, 2014
Posts
1,980
Reaction score
866
I'm really liking it. I need my Proclip holder to make it a complete solution. I also plan on hardwiring a charger to switched power to keep the Nexus 7 charged.
 
Top