Trick.Raptor
The Cracker Raptor
Welcome to FRF. Nice Raptor you picked up!
Newbie first post!
- Thread starter dhanni848
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Zeke555
FRF Addict
Welcome to FRF.
Raven13
FRF Addict
Howdy
- Joined
- Mar 15, 2013
- Posts
- 3,210
- Reaction score
- 2,342
Welcome to the forum @dhanni848!
To remove the rear emblem, insert a small screwdriver into the little slot on the bottom, then carefully pull STRAIGHT back, and it should pop loose. If you pry up, or pull back at an angle, then the emblem connectors may break. Also, there is also a chance that one of the metal prongs on the plastic connectors was bent when installed, and it will break the connector. If it does not pull off fairly easily, then wait until you have a replacement emblem in case the current one breaks.
-Dan
To remove the rear emblem, insert a small screwdriver into the little slot on the bottom, then carefully pull STRAIGHT back, and it should pop loose. If you pry up, or pull back at an angle, then the emblem connectors may break. Also, there is also a chance that one of the metal prongs on the plastic connectors was bent when installed, and it will break the connector. If it does not pull off fairly easily, then wait until you have a replacement emblem in case the current one breaks.
-Dan
stealth
Full Access Member
Welcome to the elite Raptor club!
mmaterni
Full Access Member
OP
OP
dhanni848
Active Member
Checked what seems to be the right fuse and it was fine. I checked the 10A in position 34. Maybe that sounds right?
I maybe should start a new thread in a different location too
I maybe should start a new thread in a different location too
ivo1.cox
Full Access Member
Benvenuto, welcome !
Similar threads
