Livernois released new bump sticks, lope inside!

[GoMuscles]

To rear wheels. It's the Hennessey 575 but Iv'e done more since Hennessey.

What other mods have you done bud? I live about 10 min from Hennessey and I've seen these trucks dynod at that shop and its 575 to the block... they are giving you almost 20-25% for DT loss. The one we dyno at LMR made 430 rwp and that matches the above 575 bhp numbers they advertise. Not tryn to bash at all homie just curious if your running a smaller pully and if so how much boost at peak? If not what other unholy mods have you done to get those extra ponies.

575 rwhp plus 25% is over 700bhp which is grenade territory for a stock block.

 

[IA_Raptor]

I'd still like to know what tools are needed to install these. I can likely get free/cheap access to them if I can get the part numbers.

 

[GoMuscles]

[/COLOR]

I'd still like to know what tools are needed to install these. I can likely get free/cheap access to them if I can get the part numbers.

Correct me if if I'm wrong but your going to attempt to tear down and rebuild your top end but don't know what tools are needed?

You'll need a dyno tune as well... Just ahead up.

 

[IA_Raptor]

Correct me if if I'm wrong but your gong to attempt to tear down and rebuild your top end but don't know what tools are needed? Not sure this will be as easy as you think. You'll need a dyno tune as well... Just ahead up.

I've got access to the necessary resources (with exception of the tool part numbers). I also have ALLDATA but they don't have the tools listed. And the local Ford dealer's manual just says,"use a valve spring compressor". Normally they list part numbers. I don't want to buy the cams and then sort this out. I wish to be prepared.

 

[MTF]

To rear wheels. It's the Hennessey 575 but Iv'e done more since Hennessey.

Those numbers posted on the side of the _ _ _ _ _ _ _ _ Raptors and on their website are all "want to be" FWHP.

To get 575 rwhp you would need close to 750 to 800 FWHP!!!!