hi all, i am having a bit of a issue with the install of some led switchback lights for my front turn signal/parking bowls.... when i install the led's with a new socket, these are white switcbacks that flash amber. when they are installed they will light up white for a milli second then stay off. when i use the turn indicator or the hazard lights they light and flash amber like they are supposed to.
i tried a second set of the same type of lights and they did the same thing. neither set i tried hyper or fast flashes. so i just take them out and put in the stock ambers and everything is fine. the builbs arent broiken as these lights when bench tested work as they are supposed to.
i just recieved another set from JDMtoy and these came without the socket and are to beinstalled into the socket of the existing stock amber bulbs. these also came with a 50w 60 ohm load resistor. i thought a load resistor will only address hyper/fast flashing. before i get back under the truck tomorrow and start splicing , anyone have any experience and or thoughts what could be the problem.
i tried a second set of the same type of lights and they did the same thing. neither set i tried hyper or fast flashes. so i just take them out and put in the stock ambers and everything is fine. the builbs arent broiken as these lights when bench tested work as they are supposed to.
i just recieved another set from JDMtoy and these came without the socket and are to beinstalled into the socket of the existing stock amber bulbs. these also came with a 50w 60 ohm load resistor. i thought a load resistor will only address hyper/fast flashing. before i get back under the truck tomorrow and start splicing , anyone have any experience and or thoughts what could be the problem.
