Installing Radiance Adapt 40 light bar (with pictures)

[Kurator]

Hey guys.

I decided to spend some time to install 40 inch Radiance Adapt light bar. Figured all the wires, and I need to run 1 wire through the firewall, to connect relay harness to underdash controller.

For those who done these previously, is passenger side grommet is the easiest choice?

Can I fit said wire through existing grommet to avoid drilling?

Do I need to remove wheel liner or is it optional?

If I use Radiance controller, should I still wire radiance backgroud and flood trigger wires to my aux switches?

Is it ok to leave gps module glued under dash?

Thanks alot for help!

 

[Nex]

On a Gen 2, but should still be the same. On my Switch-Pros I cut the nipple off the big grommet and ran the control wire through that. Behind the fuse box.



And when I ran power for the UHF, I went through a grommet passanger kick panel area. Easier to drop or remove the inner finder.



For the back lighting, I left the 30" attached to the parking lights but ran the 4 LP9s on uplifter switch 5. Didn't want them on all of the time. And with the Switch-Pros doing most of the work I had the extra switch.

 

[Kurator]

Thank you.

 

[Kurator]

Hey guys, is this nipple is the grommet I use to run wires?

 

[Kurator]

Install so far. Too bad light brackets came scratched from @Specialtyperformanceparts, but I think its not a big deal for me.

 

[Kurator]

More pix...

 

[Kurator]

On a Gen 2, but should still be the same. On my Switch-Pros I cut the nipple off the big grommet and ran the control wire through that. Behind the fuse box.

View attachment 434532

And when I ran power for the UHF, I went through a grommet passanger kick panel area. Easier to drop or remove the inner finder.

View attachment 434533

For the back lighting, I left the 30" attached to the parking lights but ran the 4 LP9s on uplifter switch 5. Didn't want them on all of the time. And with the Switch-Pros doing most of the work I had the extra switch.

Dude, I found out about coronaraptor from your post in this thread (reading your avatar). Thanks for keeping him alive in our forum.

 

[Kurator]

Hopefully this is a grommet?

 

[Nex]

Hey guys, is this nipple is the grommet I use to run wires?

No. Should be up and to the left. Behind the fuse box. Believe what you are looking at is the AC evap drain.

 

[Nex]

Dude, I found out about coronaraptor from your post in this thread (reading your avatar). Thanks for keeping him alive in our forum.

Wish I didn't have to. Telling @MurderedOutSVT to clean his engine bay was Corona's job...

---