High Pressure Gauge and Filler for Bump Stops

[Robtor310]

No concerns about the Nitrogen?

My SCREW is set to 110 lbs, according to the shop.

110 is a good starting point. Initially mine were at like 175psi which was too much for my driving/weight.

I havent had any issues. Looking back Id say my ambient temp swings while using were about 20-30 degrees or so max. I checked them a few times to make sure I wasnt bottoming out and the max travel remained fairly consistent.

In a perfect world a nitrogen source on tap would be great. I just dont have that setup nor has there been an issue using regular air to justify it.

 

[TXRaptor]

In case anyone else is following this thread, I heard back from Miller Offroad and here is the one they use:

https://www.kartek.com/parts/kartek-billet-pressure-gauge-for-fox-king-bilstein-or-sway-a-way-nitrogen-shocks-0-to-400psi.html

Here is another one from the Kar Tek web site:

https://www.kartek.com/parts/king-billet-360-degree-swivel-chuck-pressure-gauge-for-fox-king-sway-a-way-nitrogen-shocks-400psi.html