Go Industries Baja Rak

[chadasm]

Just wanted to post a few pictures of the Go Industries Baja Rak. Overall I'm happy with it and the fit.
The install, however, was not a very fun experience. The bolts and nuts provided seized before fully tightening and I could not back them out before stripping the heads. I ended up using a Dremel to cut off 4 bolts on the bed rails.
I then thought, "Surely the bolts holding the side panels to the main body won't be the same...?" My mistake, I had to cut 4 of these off too.
In the end I bought all new bolts and nuts and threw the rest of the ones that came with it in the trash.

But I like it!

 

[Deleted member 12951]

So are you mounting a light on top of it?

 

[t_j]

I looked at this, then looked at all the pictures of it on the internet and the trucks they were bolted to then decided I would just make my own.

 

[chadasm]

So are you mounting a light on top of it?

That will be the next step. I keep going back and forth between the Raptor and the Corvette for mods. I should stick to one and finish it out, but the ADD kicks in too soon.

I looked at this, then looked at all the pictures of it on the internet and the trucks they were bolted to then decided I would just make my own.

I would love to have made my own if I possessed the ability.