GEN3 Forscan

[Andrewalker7]

My headlights still decide to just come on in bright daylight sometimes in "auto" mode, and I remember making some change in the BCM about how the light selector switch wouldn't auto-default back to to "Auto", back in November..... but now I cannot find it in the spreadsheets to revert back to default without going back to my asbuilt files. Any guidance?

I also have the BCM set that all markers and such are DRLs, so really it's just my "headlight off" switch now.

Was thinking it would be pretty convenient, but really it just made getting out of the truck super annoying most days.

 

[omalley72]

Has anyone with a 2025 had luck with including markers to the DRL function? I’ve tried using the “cheat” sheet codes listed for the 2024 Raptor, no luck. I’ve searched this forum as well as the Forscan forum, again, no luck. Any insight would be appreciated.

 

[hamster]

Check out this thread....

FORScan and DRL

Have a 2024 Raptor. Trying to get parking lights to come on with DRL. DRL only works in Auto headlight setting. Changed BCM 726-38-01 xxxx xxxx 01 and it turned on rear tails with DRLs, but none of the other ambers / parking lights. Changed BCM 726-38-02 00xx xxxx xx, but fogs do not come on...

www.fordraptorforum.com

 

[Hemmy]

I popped my Forscan Cherry yesterday. After a couple of months I finally got some time to get into Forscan and adjust my truck from 35 to 37" tires. Speedo was off around 3 mph. Made the tire size adjustment and now the speedo is right on. Also turned off the double honk and the auto start/stop. I am guessing it is just a coincidence since I am nearing 65,000 miles, but now I have a notification when I start my truck that says "Charging System Service Soon". I checked the battery and it seemed good at both sitting and cranking.

 

[Raptorbert]

@mkraus01

Only have to make the below changes. The 726-15-01 is the same as the 1st 2 digits of the tires circumference are the same. Just the last 2 digits. 35" (0A5D) and 37" 0AC1)

37" = 726-15-02 C1xx-xx
35" = 726-15-02 5Dxx-xx

So I just did this and tried to rest the PCM DTC using reset transmission tables (thanks YouTube) instead of going though the relearn process in the as built screen area. I did the right thing and p160 went away. But, do I need to do something about that table relearn I messed up doing?