GEN3 Forscan

[tm965]

Reviving this question. Has anyone done this??

It’s in the settings for one of the modules within forscan. I found it after browsing

 

[HORN HIGH ACES]

It’s in the settings for one of the modules within forscan. I found it after browsing

I haven't located it so any assistance would greatly appreciated.

EDIT: Found it in BCM.

726-10-01	xxxx	xxxx	**--	PlacardFront_Cfg (PFC) • Psi = Hex2Dec(**) • Range: 0 - 255
726-10-02	**xx	xxxx	xx--	PlacardRear_Cfg (PRC) • Psi = Hex2Dec(**) • Range: 0 - 255

 

[tm965]

I haven't located it so any assistance would greatly appreciated.

EDIT: Found it in BCM.

726-10-01	xxxx	xxxx	**--	PlacardFront_Cfg (PFC) • Psi = Hex2Dec(**) • Range: 0 - 255
726-10-02	**xx	xxxx	xx--	PlacardRear_Cfg (PRC) • Psi = Hex2Dec(**) • Range: 0 - 255

there's also the ability to do it in the simpler menu--no need to mess with the as built values

 

[northlaker]

I haven't located it so any assistance would greatly appreciated.

EDIT: Found it in BCM.

726-10-01	xxxx	xxxx	**--	PlacardFront_Cfg (PFC) • Psi = Hex2Dec(**) • Range: 0 - 255
726-10-02	**xx	xxxx	xx--	PlacardRear_Cfg (PRC) • Psi = Hex2Dec(**) • Range: 0 - 255

How do you read this or rather what do change to get the sensitivity reduced? I'm not smart enough for that formula speak on the right

 

[HORN HIGH ACES]

How do you read this or rather what do change to get the sensitivity reduced? I'm not smart enough for that formula speak on the right

You have to select a new threshold value. Default is 38 psi which equals 26 in hex.

Go into your BCM as-built and the ** values should be at 26.

If you want to adjust the threshold to 35 psi for example, you would update the ** values to 23.

You can also select different threshold values for the front and rear if desired.

Decimal to Hex Converter

Decimal to hex number conversion calculator and how to convert.

www.rapidtables.com

 

[northlaker]

You have to select a new threshold value. Default is 38 psi which equals 26 in hex.

Go into your BCM as-built and the ** values should be at 26.

If you want to adjust the threshold to 35 psi for example, you would update the ** values to 23.

You can also select different threshold values for the front and rear if desired.

Decimal to Hex Converter

Decimal to hex number conversion calculator and how to convert.

www.rapidtables.com

Hero. Thank you!