Gen 3 Raptor 37 Geiser Rear coils install + pics

[j-man]

All right, im sooo pleased with Geiser’s upgraded rear coils for the 3rd gen Raptor. Gave a couple inches over stock height.
To start, i put these on my 22 Raptor 37 with a standard shell installed. With just the shell on, the rear was about 1/2” or so below the front height, & when i put anything more than a suitcase in the bed it was already sagging - no bueno.
I purchased the Geiser’s last week, were at my house in a few days, & just put em on. Final measurements for all of you looking to put them on ur 3rd gen are:
Front Stock height: 41 3/4”
Rear height w/ Geisers: 44 1/4”
Height of bottom of Hitch above ground: 21 3/4”.

Overall extremely happy w/ the outcome, im sure they’ll settle a half inch or so, but thats fine. Its a tad stiffer than stock, but i dont like that mushy slushy saggy feel anyway lol. Heres some pics, enjoy!

 

[j-man]

heres more pics:

 

[DMays]

Glad to know these fit. Their website says they won’t fit a 37pp

 

[DMays]

Never mind. It says the front won’t fit

 

[relak]

Great info. Might go this route when I start looking at tent setups.

Can you do me a favor and put some wheel well liners in the rear though? It’s said that the cause of global warming is actually the sun shining off liner-less GEN3 wheel wells.

 

[Chuckaroo91]

Pretty easy install? What is the torque spec on the lower shock bolt?

 

[Idaho Savage]

Do you carry anything else in the bed on the reg? Have you towed with them yet?

 

[2020FordRaptor]

All right, im sooo pleased with Geiser’s upgraded rear coils for the 3rd gen Raptor. Gave a couple inches over stock height.
To start, i put these on my 22 Raptor 37 with a standard shell installed. With just the shell on, the rear was about 1/2” or so below the front height, & when i put anything more than a suitcase in the bed it was already sagging - no bueno.
I purchased the Geiser’s last week, were at my house in a few days, & just put em on. Final measurements for all of you looking to put them on ur 3rd gen are:
Front Stock height: 41 3/4”
Rear height w/ Geisers: 44 1/4”
Height of bottom of Hitch above ground: 21 3/4”.

Overall extremely happy w/ the outcome, im sure they’ll settle a half inch or so, but thats fine. Its a tad stiffer than stock, but i dont like that mushy slushy saggy feel anyway lol. Heres some pics, enjoy!

That turned out great!

 

[dannym2009]

Assume the 44-1/4" rear height is with the shell on?

 

[j-man]

Pretty easy install? What is the torque spec on the lower shock bolt?

Super easy, torque specs are 1 1/2 grunts