Fuse 27 relocation inefective.

[ograptor]

Sorry to hear about your garage. You just can't catch a break.

 

[DCSVT1]

Sure is. Ford doesn't make them any longer so it fix it or buy one from an online site. Try fixing it first. Soldering wires is easy enough other than the crappy location.

 

[Canuck714]

Sure is. Ford doesn't make them any longer so it fix it or buy one from an online site. Try fixing it first. Soldering wires is easy enough other than the crappy location.

Any luck?
Have you tried bypassing the FPDM? This will remove the FPDM and the fuel shut off in the BCM and power the pump on full time
Get 2 pieces of wire and stick it in the FPDM plug i think its pins 1&5 and 4&8?

Should look like this.

 

[DCSVT1]

Got the harness fixed best I could due to the location and still no go. Think the harness in question is more for the O2 sensors and trans
starter. No so much the fuel pump. Key on, I've only got power to pin 1 and everything else is dead. Very frustrated and may bite the bullet and tow it to Ford.

 

[mprice1234]

Good luck!

 

[DCSVT1]

 

[ograptor]

That..... that dosen't look great