Fuse 27 relocation inefective.

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
D

DCSVT1

Full Access Member
Joined
Sep 15, 2014
Posts
105
Reaction score
18
Location
Medford NJ
Will have to start at the fuse box and trace power back to the pump. Also have a scanner but no check engine light so not sure if it'll show anything. Hate to drop the tank again but it's that or bring it to the dealer.
 
OP
OP
D

DCSVT1

Full Access Member
Joined
Sep 15, 2014
Posts
105
Reaction score
18
Location
Medford NJ
did you check all the fuses in BOTH locations? how did you cross wires hooking up a trailer? 4 pin or 7 pin?
Both locations?? And I was putting in new brake lights. Touched a hot wire to the metal trailer and blew a fuse or two plus killed the anti hyperflash resistor for the rear brake lights. Ground was not hooked up at the time.
 

The Car Stereo Company

aka grumpy car stereo guy and frf rolodex
Supporting Member
Joined
Jul 8, 2012
Posts
32,710
Reaction score
23,833
Location
here, on frf
Both locations?? And I was putting in new brake lights. Touched a hot wire to the metal trailer and blew a fuse or two plus killed the anti hyperflash resistor for the rear brake lights. Ground was not hooked up at the time.
passenger kick panel and underhood main box are the 2 locations for fuses
 

TomDirt

FRF Addict
Joined
Jan 3, 2022
Posts
3,671
Reaction score
10,494
Location
Hesperia CA
There is a feature on the dealership tech's scan tool that allows him to compare fuel pressure (at each injector) to see if they are within the same pressure range. If you're bringing it back there, it would be good to check that out.
 
Top