Foutz Light Bar

[Sig Fanboy]

Has anyone installed the Foutz light bar that retains the factory bumper on the Gen 3? I’m wondering how it mounts. Their website says the Gen 2 light bar attaches via the tow hooks. Their photos are not the greatest but from what I can see I don’t think the Gen 3 models uses the tow hooks. Isn’t the person driving Foultz’s Orange Gen 3 on this forum now?

 

[McCarthy]

I've had one sitting in the garage for months now... I'll get around to it in the next week or two. It mounts into the top of the bumper area.

 

[Sig Fanboy]

I do believe we will have to remove the bumper to mount it and guessing some trim pieces will need cut. Then deciding what lights to run

 

[rrbarrios14]

Following…

 

[QCRappy]

You dont need to trim anything, just pop off bumper then use existing 2 bolts to attach mount to then bolt back up bumper

 

[Sig Fanboy]

You dont need to trim anything, just pop off bumper then use existing 2 bolts to attach mount to then bolt back up bumper

Thanks, Is the rubber(?) trim piece pliable enough to run light wiring over without trimming it?

 

[catinthehat85]

I installed this recently. You absolutely need to trim the rubber piece or it will not sit right.

 

[socal raptor]

Installed as well last week, you definitely have to trim the rubber. It was not as quick as I thought it would be

 

[Sig Fanboy]

You dont need to trim anything, just pop off bumper then use existing 2 bolts to attach mount to then bolt back up bumper

I see now that you detached the entire rubber seal assembly and I guess ran it back over top of the light bar mounts. I guess I didn’t pick up on that before. I ended up just cutting the plastic part of trim on either side of the mount. I guess it works either way.
Have you mounted any lights yet?

 

[QCRappy]

No I dented my stock bumper so I upgraded to aftermarket and sold the foutz bar