Curved 20" LED bumper light install

[menerso]

I looked all over to see if anyone had a curved 20 inch light in the front bumper. I didn't find any pictures so I figured I would show you what it looks like. I don't need to go through the install since there are several other threads for that.

Looks good. Pain in ass getting the side screws tight, but I got it down.

Also, lowered my license plate too.

 

[Iman]

Looks clean.

 

[cheesehead]

looks great! Forgive my ignorance, but what lightbar is that?

 

[menerso]

I got it on amazon for $250
Amazon.com: 20in 120Watt, CURVED CREE LED Light bar with 3D Optics- by LuxWurx: Automotive

I used the Rigid mounting bracket $29
Amazon.com: Rigid Industries 40133 Lower Grille Kit for Ford Raptor: Automotive

I had extra wiring from my Rigid D2s, so I used that for the wiring.

looks great! Forgive my ignorance, but what lightbar is that?

 

[justvettn]

I guess you don't do any offroading with that license plate?

 

[menerso]

I will just remove the plate when I go

I guess you don't do any offroading with that license plate?

 

[raptrcrzy]

I got it on amazon for $250
Amazon.com: 20in 120Watt, CURVED CREE LED Light bar with 3D Optics- by LuxWurx: Automotive

I used the Rigid mounting bracket $29
Amazon.com: Rigid Industries 40133 Lower Grille Kit for Ford Raptor: Automotive

I had extra wiring from my Rigid D2s, so I used that for the wiring.

odd...that link for the light bar doesnt work...could you please post it again?

 

[menerso]

Works for me. You can do an Amazon search for the words in the link.

odd...that link for the light bar doesnt work...could you please post it again?

 

[Camarors64]

How did you mount your license plate? How is the output of your bar?
It looks like you used the rigid mounting bracket, did you just follow rigids instructions?

 

[menerso]

I did use the Rigid mount. I went by their instructuctions other than i drilled holes @ 2" from the edges (there was a lot of room)

As for the plate, I drilled new holes in the bottom part of the bumper and put threaded inserts in. The plastic factory plate mount fit perfect and the hooks on the back of the mount are pressed up against the bumper so that it supports it too.

Output is really good. I have a 30" that is on order and I am putting that one behind the grill. The combined output will be more than enough... but I say that now.

marty

How did you mount your license plate? How is the output of your bar?
It looks like you used the rigid mounting bracket, did you just follow rigids instructions?