COBB FMIC and K&N Boost tube Gen 3 Install Video Request

[Relentles0ne]

Need some help from my fellow Gen 3 members. Looking to self install COBB FMIC (non factory location) with Turbosmart BOV and install K&N boost tubes on my ‘24 801a Raptor.
Been searching all over for install / instruction videos and I’m coming up short here. Found a few for factory location Cobb intercooler change outs, but nothing for high mount intercoolers for Gen 3 models and no Gen 3 install vids for the boost tubes.
Anyone who’s done these installs themselves care to share any useful guides or videos they used for their install?

Cobb has some older instructions on their website that only go up to ‘21 models so I’m nervous to stick to that and miss something critical on the newer models have that I need to account for.

 

[James O]

The installation is going to be very similar to the instructions on Gen 2. The most difficult part for me was removing the lower trim piece between the bumper and grill to get to lower bolts on grill.
You will also need 2 grill shutter motor simulators to prevent any check engine lights on 24s.

2024+ Ford F-150 Raptor Shutter Motor Relocation Kit

Our F-150 Raptor Shutter Motor Relocation Kit provides the perfect solution for when you purchase aftermarket/off-road front bumpers and need to change the mounting location of your shutter motor. Brushed aluminum finish and made in the USA.

www.addictivedesertdesigns.com

I have done 3 FMICs for 20, 23, and 24 and they are all essentially the same.

 

[Relentles0ne]

The installation is going to be very similar to the instructions on Gen 2. The most difficult part for me was removing the lower trim piece between the bumper and grill to get to lower bolts on grill.
You will also need 2 grill shutter motor simulators to prevent any check engine lights on 24s.

2024+ Ford F-150 Raptor Shutter Motor Relocation Kit

Our F-150 Raptor Shutter Motor Relocation Kit provides the perfect solution for when you purchase aftermarket/off-road front bumpers and need to change the mounting location of your shutter motor. Brushed aluminum finish and made in the USA.

www.addictivedesertdesigns.com

I have done 3 FMICs for 20, 23, and 24 and they are all essentially the same.

Thank you my man! Greatly appreciate the info here, I had just learned yesterday about needing two motors and got them on order now. Had no idea about their being upper and lower shudder motors.

How about boost tubes any experience with those? @James O