ADD "ed" pro bolt on front bumper + BD lights

[smgilles]

Did you relocate your ACC? And if so what bracket did you use? Im about to install mine and i got the BajaMod ACC bracket but cant find any install guide or write ups from folks who have done it.

I do not have ACC on my 802A.

 

[Tomhorn]

I would be careful putting anything there if u havent relocated your turbo intercooler even front plate blocks it ****** placement. I have a 14 which light bar is great there. 19 i got 42 “ bar from f150 leds and set up 3 fogs sae white amber infared be careful of the intercooler is my only advice theg run hot

 

[Gaptor]

I would be careful putting anything there if u havent relocated your turbo intercooler even front plate blocks it ****** placement. I have a 14 which light bar is great there. 19 i got 42 “ bar from f150 leds and set up 3 fogs sae white amber infared be careful of the intercooler is my only advice theg run hot

I have 0 problems with my intercooler and heat soak. With the CVF I run about 25 degrees over ambient at a cruise.

 

[Gaptor]

Overall it was an easy install even by myself. It's a clean and simple design. Fingers crossed it doesn't rust..... I still haven't figured out how to attach my front plate (swarfworks vs 3M tape?). I had the fog lights set up with spots, driving combos, and S2's, so wiring already in place for adding the amber driving/combos. I moved the S2's to the rear.

View attachment 145053
View attachment 145054
View attachment 145055
View attachment 145056

I used black zip ties to hold it to the add cutouts on mine and looks fine

 

[Miggy]

I have the bumper and used add’s bracket relocator. It turned out fine. The relocation of the acc is a pain in the ass but it works fine.

 

[smgilles]

Thanks for the plate ideas guys! Also, my Whipple IC runs much cooler than previous stock IC too. I measure temps via COBB AP.

 

[hekster1]

Nice

 

[BroncoAZ]

I used black zip ties to hold it to the add cutouts on mine and looks fine

View attachment 145106

Is that a 30” or 20” SR bar?

 

[Donovan]

Good to know that people have a nice looking aftermarket front bumper without having to relocate the FMIC.

That is another few hours of work.

What other bumpers can be used that doesnt require FMIC relocation?

 

[chi_weezy]

I’m also about to install this bumper. Figured I’d throw in the CVF IC while I was at it. Tackling this project soon