Search results

In other forums I am a member of (AR15.com) they always have a stickied Black Friday/Cyber Monday deals thread....we need something like that

Christopher Butler US Navy 8 years. 1996-2004

I actually went with 80%, but it still affects the sensor.

I will have to see if I can find it. Hopefully I did not throw it away. Thank you for the info!

I bought them knew from a vendor, and the kit shipped directly from Baja Designs

I believe it was the bracket that comes with the Baja Designs kit

What part of Houston? I am in Katy, and did quite a few changes on mine. Its not hard at all

I installed my Baja Designs fog pocket kit. The SAE fog light sits right on the bumper when aligned. Anyone else come across this issue? If so, how did you remedy it? I don’t want the bumper and light to wear there, and I may end up wanting to put amber covers on the fog lights, but won’t be...

Nope, nothing yet. Not sure if it is even possible…

What all is entailed in this install?

So, is it best to just install this ourselves? Or is it 100% required that it is installed by a dealer?

Has anyone else installed this themselves? And once I remove the tune, would I be able to sell the tuner, or is it worthless for anyone else? Just was thinking to use this until Goose comes out with a tune for the 23

Anyone figure out how to adjust the brightness/dimness that the auto headlights come on? I tinted my windshield, and the headlights come on/stay on too early/too long

Cool. I guess we shall see if I can notice a difference tomorrow then.

Here are my current reading on a stock ‘23 35” truck, other than some 17” Methods. Should I recalibrate it?

Do you wish you had went with 5 instead of 4 lights? And what pattern are the LP6's you went with?

My measurements right now are 40.5” front, and 41.5” rear. I have the SDI top hats ready to go, but am thinking to either go with the Eibach 1.5” rears, the RPG 1” spacers, or the RPG 2” spacers. Need to decide soon, as I want to get these top hats installed

I am going to be ditching the OEM 35" KO2's after having 3 of them replaced under warranty for being out of round, and starting to have the same problem again 8,000 miles later. I am looking at Nitto Ridge Grappler's, Toyo Open Country R/T Trails, and Falken Wildpeak AT4W's. which on of these...

Truck updated itself on Monday afternoon, and now the "R" button no longer works. Anyone else have this issue?

Yup, I also looked this morning, and measured again. They sent me the wrong box. I am returning it, and they are hopefully sending me the correct box.

Inside the bed rails is about 62.75 inches. The measurement on the box appear correct from the schematic I saw online. It is just about and inch too short

Yea, here is the one I ordered sitting in the bed. Definitely not wide enough.

What Gen is your raptor? When I tried to set the box on the bed rails, I only had about 1/2inch of engagement, and could get it to stay on the rail. It’s definitely to short for my Gen 3

Which one did you go with?

I ordered a UWS 69in low profile box, which is what UWS said would fit, but it is not wide enough. So, I am looking for something low profile, and slim so it doesn’t take up too much of the bed. What is everyone else using for a bed mounted toolbox? I need some ideas, please.