I ordered a UWS 69in low profile box, which is what UWS said would fit, but it is not wide enough. So, I am looking for something low profile, and slim so it doesn’t take up too much of the bed. What is everyone else using for a bed mounted toolbox? I need some ideas, please.
Need a toolbox, what is everyone else using?
- Thread starter AARaptor
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
HighwaySentinel
︻デ┳═ー - - - - - - -
Here's mine. It fits.
Honestly, you won't find a lot of trucks on here with the kind of toolbox you are talking about.
Honestly, you won't find a lot of trucks on here with the kind of toolbox you are talking about.
Sharpie69
Full Access Member
I've got the UWS low profile, it's been in the bed since 17 and has taken plenty of abuse, no complaints
Which one did you go with?
I have one of those husky 72 piece tool boxes and some breaker bars portable pumps and large sockets. And zip ties. Lots of zip ties. If I can’t fix it with that I’m calling for the heavy wrecker or trail mater.
Sharpie69
Full Access Member
Sorry, I don't recall and I'm not near my truck at the moment. I'll take a look inside the box and see if I can find anything for you later on
Sharpie69
Full Access Member
Looks like I have the 69in tool box, you can see the gap on either side, works fine for me, I can just reach the fwd tie down anchors
Attachments
What Gen is your raptor? When I tried to set the box on the bed rails, I only had about 1/2inch of engagement, and could get it to stay on the rail. It’s definitely to short for my Gen 3
Sharpie69
Full Access Member
I have a 2nd gen, 62" from inside to inside of the bed rails
Shane361
FRF Addict
Last edited:
Similar threads
