Where to run the wires for 54" RDS with ADD mounts?

[FordRaptor813]

I've got the brackets installed and the light on. I can't figure out where to run the wire for the aux hook up. I've got it running down the passenger side....

 

[justvettn]

I have seen it run around the A pillar to the door jamb side or straight down between the windshield and A Pillar.

 

[FordRaptor813]

Ok thanks I'm going to give that a try. I wish someone was open that I could call that has done one before. Thanks again. Anymore suggestions are appreciated.

 

[justvettn]

I have seen pictures of the wiring run for the RDS roof mount and did a search for pics but could not find what I was looking for. It is on the Forum just a matter of searching.

 

[FordRaptor813]

Your advice was good. I pulled back the rubber molding on the pillar and sure enough there was a hole leading right above the engine bay. Thank you! You wouldn't happen to know anything about the resonance dampeners they send with the lights? I haven't installed them yet and the light makes a nice little hum at 60

 

[CP RAPTOR]

@iSurvive I believe could give some insight to the dampers, I've read before that they work quite well and I think it was him. I would put them on personally.

New sounds are cool when the part is new, let's be honest we all put even the smallest thing on the truck and want to drive it, look at it, show it off and hope people notice but in the long run noises like that and drone start to become a frustration over time.

 

[justvettn]

They mount to the back of the fins.

---------- Post added at 12:02 PM ---------- Previous post was at 11:59 AM ----------

http://partners-rigidindustries.com/images/EseriesResonanceDamper.pdf

Rigid instructions link for Resonance Dampers.

 

[FordRaptor813]

Thanks guys this was a huge help! I really appreciate it. I'm going to install them in a bit.

 

[justvettn]

When you're finished and get a chance, post a picture.

 

[FordRaptor813]

Will do I'll try and get one up tomorrow.