Whats on your truck with Line-X on it?

[BLACKMAMBA777]

bed, rear wells, rockers and flares. then i ran outa money

My line x guy said the flares would be tough to do due to the 3MM used to hold them to the truck. Hmmm

 

[FreightTerrain]

My line x guy said the flares would be tough to do due to the 3MM used to hold them to the truck. Hmmm

mine have been holding up good. been almost a year. no sign of the flares loosening

 

[WilsonRaptor]

For sure doing the inner fenders! What about the bed side factory rails the two plastic pieces as pictures below! And then the plastic piece on top of the rear bumper pictured below! And I'm going to plasti dip the fender flares hood vents side vents rear bumper part that's not linex and the front grille! I'm also thinking of plasti dipping the whole bedcover what do y'all think?

 

[wanderfalk]

has anyone removed the top rails that cap the bed and line xed the top of bed?

 

[nowplaying]

Started with the flares than moved onto the front and rear bumpers. Picked up a Ford Racing light bar from a FRF member and had it Line'X to match. Oh, and the bed is Line'X also.

 

[69Mach1]

Started with the flares than moved onto the front and rear bumpers. Picked up a Ford Racing light bar from a FRF member and had it Line'X to match. Oh, and the bed is Line'X also.

I like the flares line'Xed! Do you have a pic before you did the bumpers? Still on the fence about getting them done.

 

[nowplaying]

I like the flares line'Xed! Do you have a pic before you did the bumpers? Still on the fence about getting them done.

Unfortunately I don't. I had the front and rear bumpers Line'X'd a week after the flares. The gray on the bumpers didn't flow right once the flares were blacked out.




Sent from my iPhone using Tapatalk

 

[Sano Dano]

Line-Xed the bed, flares, front and rear bumpers, wheel wells, and the lower front grill.

Like the idea of doing the rocker panels.

 

[69Mach1]

Unfortunately I don't. I had the front and rear bumpers Line'X'd a week after the flares. The gray on the bumpers didn't flow right once the flares were blacked out.




Sent from my iPhone using Tapatalk

Np, thanks. Did you have to remove the flares & bumpers to get them lineX'd?

 

[nowplaying]

Np, thanks. Did you have to remove the flares & bumpers to get them lineX'd?

Yes. Line'X doesn't bond to plastic so the flares in particular have to be completely encased in Line'X to create a seal.

I forgot, I had my skid plate covered in Line'X too.


Sent from my iPhone using Tapatalk