tom wansor
Full Access Member
Installed ADD Bolt on and BD 20 inch ONX+. Hoping for some sales once this virus thing is over so I can get some wheels.
What did you do to your Raptor today? (Gen2)
- Thread starter Jepper
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
edubpdx
Active Member
Installed front and rear JLT performance mudflaps and stainless steel American Car Craft Raptor bling to my running boards
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
alphatwox
Full Access Member
How much of a paint in in the ass is it to relocate the ACC? The bumper itself is so straight forward, but its like 80 more steps just for the bracket shift.
tom wansor
Full Access Member
The ACC bracket was most time consuming part. Removing grille without damaging clips or scratching paint was a pia. I did whole thing by myself except for mounting bumper.
CDN_Raptor
Member
Had my Offroad Alliance triple bezel wrapped with matte PPF (comes powder coated gloss black) and PPF applied to the lenses of the BD Deigns lights going in them.
Braaaaptor
Starbucks Enthusiast
Removed the BLIS stickers from the tail lights, new license plate holder, and put on a Ronin Factory stubby antenna.
G_Dawg
Member
Did the first oil change at 2k miles. Even after reading about it and watching videos, I still made a mess! I did put on a Fumoto, so should be cleaner next time. Luckily the factory filter was hand tight, because using a strap wrench one handed through the access door was not going to be easy.
Did some last minute work to go out on some trails tonight. Huge thank you to Nick at Apollo Optics for getting everything here on time to make the run happen! My go to parts guy hands down! Got the Builtrite racks installed, 10lb powertank setup mounted, 3 ton Proeagle mounted. Just need to get my rotopax canisters in next and I’m ready for anything!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Did some last minute work to go out on some trails tonight. Huge thank you to Nick at Apollo Optics for getting everything here on time to make the run happen! My go to parts guy hands down! Got the Builtrite racks installed, 10lb powertank setup mounted, 3 ton Proeagle mounted. Just need to get my rotopax canisters in next and I’m ready for anything!
Sent from my iPhone using Tapatalk
Right on, man! Glad we could get you everything you needed and there one time for your setup! Enjoy the run and stay safe!
alphatwox
Full Access Member
Installed some Baja Designs Squadrons on the pillars...
Similar threads
