Upgraded inner fog to pro, swapped internals

[DatGuy14]

The pro fog units I bought, were plug-in play, essentially. You open up the housing on each and pull the boards out. Then swap the pro board into the factory housing.
When I did the units on my 2021, I had to do some soldering, so I’m not sure which ones have plug-in play boards. It may have been an older unit as well.

I'm wondering if I could do this without removing them form the truck?

 

[Syberspace]

I'm sure the neighbors were super stoked about your new lights.... lol

I'm sure the neighbors were super stoked about your new lights.... lol

Ha, not a problem. Good friends with them. I upgraded again… went to 3” cubes. SAE fog and hyperspots in the outer bumper and a 10” SR Pro driving/spot in the lower center grill.