RS-R
Member
Looking at the TE37 for my Gen3 37 PP - will a 13.5 tire have a lot of cutting to do to not rub? Or is the consensus to stick with the 12.5 wide? Any input would be appreciated!
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Looks awesome! Do you have any pics head on showing how much "poke" there is with that offset? Also, what size tires are you running?View attachment 369488
Any other center cap alternatives yet for the TEs?
Looks so good!View attachment 369488
Any other center cap alternatives yet for the TEs?
Purchased a second gen and looking to swap over to a TE setup like most on here. Currently it has installed Vorsteriner 20 inch wheel with a 35x12.50R20LT nitto ridge grappler tire. Not terrible of a setup, just not what I ultimately want.
My question is, would you expect the 37 inch tire and TE setup most of you are running be an issue coming from the above spec? If my calculations are somewhat correct, there shouldnt be much of a difference, ~2mm at most.
You know what, youre absolutely right and I apologize for the extra chromosome I mustve had yesterday.There will be a 2inch difference. You will need to trim a little. I think you are mixing up the Rim diameter to your current wheel to the TE 18inch, yes the wheels are 2 inches smaller but going to a 37inch tire will make your setup 2 inches bigger.