Turbo Smart BOV issues!!

[Tim Eldredge]

So I just finished installing the Mishimoto Intercooler and Turbo Smart BOV on my 2020 Raptor.
TS-0215-1371. The Intercooler was a hand full to get in w the cooling fans ect but patients and got it all put to gather. New BOV installed w all connections made. I just wanted to start it before I had to call it a night and on just start up no warning lights or check engine light. But the truck is back firing now with little Rev on the gas. So I'm wondering if the blow off valve is not adjusted right and the spring tension is to hard or to soft.

Does any1 have any info or experienced this before ?
I checked all over YouTube and there's no info on adjusting this BOV!!

 

[B E N]

Check to make sure none of your intake piping came loose. It sounds like you have a leak somewhere between MAF and throttle body.

 

[Tim Eldredge]

I found a trouble shooting instructions on Tutbo smarts website this morning. I followed the procedure and it all checked out.

I increased the spring tension 6 full turns and all is good now!! I think it was to soft original so the BOV wasn't holding any pressure!!

Thank you all!!