Torque specs

[JSIN138]

All credit for this goes to pirate air. Thanks for this info, You Da Man!
I just took the numbers from the OP & put them into a 1 page reference sheet. After I did this, I figured the right thing to do is share it with anyone interested.

Inside the attached file TorqueSpecs.zip is the PDF



**Disclaimer** - refer to post #1, same applies here.

--Cheers

 

[ABNRAPTOR]

Hey Pirate air, I'm going to google these so I'll have 'em for tomorrow, but here is a list of things I want or need to get a good torque on after a exhaust system swap. Might be good stuff to add to your list.

Manifold/Header bolts
motor mounts
transmission mounts/ crossmember support.

 

[pirate air]

Hey Pirate air, I'm going to google these so I'll have 'em for tomorrow, but here is a list of things I want or need to get a good torque on after a exhaust system swap. Might be good stuff to add to your list.

Manifold/Header bolts
motor mounts
transmission mounts/ crossmember support.

Sorry, just saw this. If you still can't find them shoot me a pm and I'll see what I can dig up.

All credit for this goes to pirate air. Thanks for this info, You Da Man!
I just took the numbers from the OP & put them into a 1 page reference sheet. After I did this, I figured the right thing to do is share it with anyone interested.

Inside the attached file TorqueSpecs.zip is the PDF



**Disclaimer** - refer to post #1, same applies here.

--Cheers

That's freakin awesome! Nice job

 

[Big Brother]

Printed and going in the glove box. Thanks!

 

[NickPic83]

Hey Pirate air, I'm going to google these so I'll have 'em for tomorrow, but here is a list of things I want or need to get a good torque on after a exhaust system swap. Might be good stuff to add to your list.

Manifold/Header bolts
motor mounts
transmission mounts/ crossmember support.

I am also looking for these specs. Anyone know?

Sent from my DROID RAZR using Tapatalk 2

 

[BIRDMAN]

I'd say 50 on the headers and 100 on the motor/tranny mounts and cross member? if that seems too tight then just use the good n tight method and recheck after a couple days.

 

[NickPic83]

ok so what i am hearing is do the header bolts in 2 stages. 18lbs then 24lbs.

 

[Hockster]

There are many torque application charts available online. Each fastener has a set range that should torqued to.
All set with Proof load, applied torque yield strength accounted for. IF you want the correct torque for a different grade or a diff material type just call one of the fastener companies and ask what torque you should use. I guarantee that SW will have a torque chart available for you.

 

[BIRDMAN]

ok so what i am hearing is do the header bolts in 2 stages. 18lbs then 24lbs.

What size are the bolts? That seems awful weak for bolts that are notorious for coming loose due to vibrations.

 

[BIRDMAN]

Wiz you're liking posts in here, but what are your thoughts?