OP
OP
Tire rubbing Boatec fender liners
- Thread starter Flaltlander1414
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
OP
OP
Flaltlander1414
Full Access Member
The uca's are on the right side
Stock wheel offset is probly the issue. A 0 offset wheel like a method will move it out a 1/2 in. Get the wheels o. First then play with it. Also make sure the the wheel wells arnt pushed out a little. Put the fender on to check
Dave Venti
Dave Venti
NickPic83
FRF Addict
Good thinking dave
Sent from my XT1080 using Tapatalk
Sent from my XT1080 using Tapatalk
OP
OP
Flaltlander1414
Full Access Member
Im with you on the wheel offset. I was hoping to not have to buy wheels yet but I might have to. Those pic are with fenders completely installed. Everything looks like it is where it needs to be. Thanks for the help
---------- Post added at 03:05 PM ---------- Previous post was at 02:47 PM ----------
Im with you on the wheel offset. I was hoping to not have to buy wheels yet but I might have to. Those pic are with fenders completely installed. Everything looks like it is where it needs to be. Thanks for the help
---------- Post added at 03:05 PM ---------- Previous post was at 02:47 PM ----------
Im with you on the wheel offset. I was hoping to not have to buy wheels yet but I might have to. Those pic are with fenders completely installed. Everything looks like it is where it needs to be. Thanks for the help
OP
OP
Flaltlander1414
Full Access Member
I talked with ADD today and Mid perch will do the trick. Hopefully. Thats a worry off my shoulders. Thanks for all your suggestions
kawie95
Full Access Member
I assume if stock tires rub with the stock wheel offset and bottom perch, that my 37" projects (which already rub on the wash fluid on full compress) will rub as well with 0 offset methods?
Similar threads
