Stay away from Mishimoto Radiators

[radelow]

This has been discussed before but I just want to add one more voice to this. *DO NOT* buy the Mishimoto Raptor radiator. My first one started leaking from the driver side end about six months after I bought it. I had to pay some ungodly amount to ship it back to them and then have them ship me a new one. Now the second one is leaking from the very same place. These radiators are absolute rubbish. I am going to make the switch to Full Race and see if I have any more luck.

 

[Stormtrooper]

This has been discussed before but I just want to add one more voice to this. *DO NOT* buy the Mishimoto Raptor radiator. My first one started leaking from the driver side end about six months after I bought it. I had to pay some ungodly amount to ship it back to them and then have them ship me a new one. Now the second one is leaking from the very same place. These radiators are absolute rubbish. I am going to make the switch to Full Race and see if I have any more luck.

Full Race are good, but if you really want to maximize your cooling go with a CBR or Ron Davis.

 

[Gumby]

This has been discussed before but I just want to add one more voice to this. *DO NOT* buy the Mishimoto Raptor radiator. My first one started leaking from the driver side end about six months after I bought it. I had to pay some ungodly amount to ship it back to them and then have them ship me a new one. Now the second one is leaking from the very same place. These radiators are absolute rubbish. I am going to make the switch to Full Race and see if I have any more luck.

Thank you.... I had one in my cart. for a while now along with the tranny cooler. Dodged that bullet. Thank You again !!!!!

 

[1BAD454SSv2]

I have a Ron Davis radiator , piece of artwork , if you can swing the price . But once cry once

 

[pat247]

@Gumby As far as the transmission cooler goes, the ford F250 cooler fits the stock RaptoR location perfectly. The only modification needed is to trim about 1"-2" off the top hose.

 

[radelow]

$1700+ is quite a bit to swing for a radiator that could get taken out by a rock... Not sure I am willing to part with that much coin for it. But thank you everyone for the advice!

 

[Marlboroman]

Maybe have a welding shop try and run a good thick cap bead on that thing. Better yet have them weld the **** out of it. Better than eating it altogether.