Spyder Industries bull bar

[JTMurph00]

Bull Bar - Must Have Push Bar From SEMA 2012 - Spyder Industries

Anyone running one of these? I saw one on a Tundra in a parking lot, it looked great and pretty well built. I tried a search but only got results for spyder lights.

 

[Nick@Apollo-Optics]

Looks tough, but will probably need to be modified to fit the Raptor.

Expensive though...

 

[joekai]

http:// http://www.spyderindustries.com/bull_bars.html

Here is a link to the bull bars. I hope I didn't screw it up. You can get them cheaper at summit racing than direct from spyder. I plan on getting one at some point.

Ok link works now. But just realized its the same as OP'S

 

[Rookie]

Link doesn't work. Cool design but not for everyone.

 

[Ni9mm]

Paint it red and then you can kiss some ass.

Hang two 4 inch Rigid in there and you'll look like Tow Mater.

 

[Humvee21]

Looks like a good start to a nice looking grill guard

 

[Fred]

Not bad at all...it is a different look...

 

[JTMurph00]

Thanks for that summit link that is a bit cheaper.

I agree it would be a good start, I was thinking of adding horns of to each side for protection but between buying it then the time to fab up sides might as well get an ADD front replacement.

 

[FvilleRaptor]

I was wondering if the OP ever got this. I am looking to get one but want to know if it fits on the Raptor without modification. Summitracing shows it as fitting up thru a 2012 raptor. I have a 2013, but there should be no difference in the front tow hooks which is what it attaches to I assume. Any input would be great. Thanks guys

 

[FvilleRaptor]

So does anyone have the Spyder bull bar? I am really wanting to get one, but I don't know if it is going to fit without modification.