Smurfrunner -- Sold

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Status
Not open for further replies.

Jetjock15

Member
Joined
Apr 30, 2022
Posts
47
Reaction score
53
Location
Texas
The OG #Smurfrunner luxury prerunner. Fully gone through and ready to run. $200k + invested over last ten years. $75k.

yes there is full build threads and the original FS add on here, well known truck. It has been fully gone through twice since first sold and another $100k into it. She good to go.


2010 Raptor, full build at 55k miles, currently at 67k. Heat/AC/Power/Big stereo/ all suede interior/hidden cage. Engine is fully built.

Linked/Caged/Supercharged, Fox 4.4 5-ways/3.5 Coils/3.5 Bumps, 18.5/24" travel, 2wd, 55 gal race cell, 39s on beadlocks.



Currently has white wrap. Underneath is graphite gray custom paint. Way too much to list in the ad space but all specs available on request. Text is best way to communicate. Truck is currently stored in Amarillo Texas right off I-40. I can haul it to Vegas or CA after paid in full or you could drive it on interstate from here to either coast, reliable and great street manners.



Was used for the Donnies 2 film and driven by BJ Baldwin and Ken Block w/custom wrap for the event. (see pics)



Truck was SVC flagship and many parts still sold with “smurfrunner” title.



Falken Tire National campaign ad poster truck twice. Was featured ad in Men’s Health Magazine ect. See video/pics



Trucks has some air time but has been fully gone through and is 100%.



Full build documented and original ad from SVC:

https://svcoffroad.com/blogs/completed-builds/svc-smurfrunner



https://www.fordraptorforum.com/threads/svc-smurfrunner-up-for-sale.47502/



Was Falken Tire national campain ad truck twice, see pics and video:




Front:

2.5” coilovers

3.5” 3 Tube

2.5” bumps

1.5” Uniball Upright

Rear:

SVC Full back Half 1.75” .0120 wall 4130

SVC 4 Link

3.0 coilover

4.4” 5 tube bypass

2.5” bumpstops

56” lower Links

2” 42130 Upper Links

Currie F9 Raptor Axle 6x135 w/ Detroit locker and 5:13s

TT Sway bar



Engine:

Full build spec sheet on request

2.3L Whipple SC

60lb injectors

3.625 pully

Whipple Heat Exchanger and pump

ATI balancer

Power steering Dual Fan CBR cooler

Dunehoon tuned

ARP Head/Main/Crank studs
JE Pistons
Manley H beams rods




Exterior

Harmon 55 Gallon cell, Brand new bladder, race certified

Glassworks Unilimted +4 fenders

New Brakes and Calipers (2023)

CBR Coolers for PS, Oilx2, Trans

Winch WARN 4.5 Synthetic

Led Headlights

5:13 Gears Detroit Locker

BD lp9s on top lp4s front



Interior:

Master Craft 3Gs on Slides w/ Schrothe Racing Camlock 5 points

Dual battery switch

Lowrance GPS

Kenwood Radio

PCI Intercomm (all seats)

Police Siren

10” Rockford Fosgate Sub, 5 Channel Amp, 4x7 Alpine door speakers



Extras:

Bucket seat for rear (center mount)

4:56 gears

40” Toyos (50%)

Sand Master 35.5 #2s on Methods

IMG_7120.JPGIMG_7121.JPGIMG_6617.PNGIMG_6563 2.jpgIMG_7138.JPG
 
Last edited:

HighwaySentinel

︻デ┳═ー - - - - - - -
Joined
Dec 13, 2020
Posts
1,792
Reaction score
3,937
Location
California
crazy huh. Less than a new Raptor. But w/out financing buyer pool much smaller. It is a steal for sure.
No kidding. I thought I remember @Stormtrooper talking about building or buying something like this a while ago. And here it is...served on a silver platter.

Good luck with the sale. I'm sure it will be quick.
 
Status
Not open for further replies.
Top