Side vent lights

[6ner]

Yes sir. Just cut the string into 2 sets of 5.

---------- Post added at 04:08 PM ---------- Previous post was at 04:05 PM ----------

I actually like the look of the ambers since the fall in line with the front markers an add unity. I wanted to go red but do not regret the decision. I will be doing the SVT cutout soon. Also going to put red leds in the bed eventually and will use oznium. Good prices and delivery was quick from Colorado.

 

[infinitereality]

The original LED pucks died after about 18 months. Well, they weren't totally out but 2 LEDs were only lit on one side and 3-4 on other side. Decided to use LED strips this time, 3 per side. They are way brighter than the pucks were when new.

With garage lights on



With garage lights off, doors shut and only light is through the garage door windows.

 

[J DAMAGE]

The original LED pucks died after about 18 months. Well, they weren't totally out but 2 LEDs were only lit on one side and 3-4 on other side. Decided to use LED strips this time, 3 per side. They are way brighter than the pucks were when new.

With garage lights on



With garage lights off, doors shut and only light is through the garage door windows.

Looks good, I see you didn't cut the SVT logo out of the fender.

 

[infinitereality]

Nope I haven't cut it out yet. I have an idea for when I do, but just too dang cold to think it thru and mess with it.

 

[J DAMAGE]

Nope I haven't cut it out yet. I have an idea for when I do, but just too dang cold to think it thru and mess with it.

Agree this weather put a damper on a lot of things, good job, keep us updated.

 

[Buckeyesvtraptor]

Here's mine. Looks great and easy to do

Sent from my iPhone using Tapatalk

 

[SVTLOPEZ]

Noah, is the material white when its not lit?

Did this mod this weekend. Tapped into the LED marker lights in the loom on the driver's side. I then ran the wires across the back by the fire wall from one vent to the other and covered that in split plastic loom. I didn't wrap it in electrical tape yet because I plan on installing hood vent LEDs next weekend. I will tap into my new wiring for that mod. I also dremeled out the fiberglass behind the "SVT" cut out so that the light would shine through that as well. I then touched up the cut areas with Tuxedo Black touch up paint. Below are the pics of my install.

Which wire is the day time running light? I want to be able to run these lights with the headlight knob rather than the aux switch

 

[The Car Stereo Company]

tie it in to the parking lights or accessory power

 

[SVTLOPEZ]

Did you connect the positive and negative with tap?

---------- Post added at 08:02 PM ---------- Previous post was at 08:00 PM ----------

Did this mod this weekend. Tapped into the LED marker lights in the loom on the driver's side. I then ran the wires across the back by the fire wall from one vent to the other and covered that in split plastic loom. I didn't wrap it in electrical tape yet because I plan on installing hood vent LEDs next weekend. I will tap into my new wiring for that mod. I also dremeled out the fiberglass behind the "SVT" cut out so that the light would shine through that as well. I then touched up the cut areas with Tuxedo Black touch up paint. Below are the pics of my install.

Did You connected the positive and negative ends of the LEDs with tape?

 

[BobboZR2]

Did you connect the positive and negative with tap?

---------- Post added at 08:02 PM ---------- Previous post was at 08:00 PM ----------



Did You connected the positive and negative ends of the LEDs with tape?

No; I soldered them and then wrapped in electrical tape.