GEN 2 S1 backup lights install part II - running wire to engine compartment inside the frame

[Todd Turbo S]

Great write up. Thank you.

 

[Raptus]

Thanks for taking the time to do that! I will be using it to wire my reverse lights for sure!


Sent from my iPhone using Tapatalk

 

[metalwhiz]

I just installed BD S2 reverse lights. 4X4 LEDs.com included upfitter harness for free. I had a fish tape, but used a piece of coax cable instead. Shoved it through the frame from the front, all the way to back. Then taped the two leads from the harness to coax and pulled back to front easily. Seems like it would be more of a hassle to run outside of frame.

 

[Refugio]

I just installed BD S2 reverse lights. 4X4 LEDs.com included upfitter harness for free. I had a fish tape, but used a piece of coax cable instead. Shoved it through the frame from the front, all the way to back. Then taped the two leads from the harness to coax and pulled back to front easily. Seems like it would be more of a hassle to run outside of frame.

Yep
Nice a safe inside the frame

 

[Big_Thick]

Thanks for taking the time to do that! I will be using it to wire my reverse lights for sure!

Same here.

Thanks @Palmetto_Raptor !!

 

[northerner77]

Great write up. I will be installing these soon.

 

[Palmetto_Raptor]

and the final touches of putting 3/8" split wire loom over wire where is goes into frame

 

[amREADY]

This is perfect. Will also try the coax on the OffRoadAlliance S2's install... thanks.