Rear Bumper Lights

[mwaite09]

Well, after about 4 hours and using a tool I’ve rarely used, I completed the install of my rigid dually flush mounts. It saved me $200 by not having 4wheelparts install them and really was not that hard to do.

I was not a big fan of the black flush mounts but didn’t want to paint them so I covered them with some grey carbon fiber, (that I can always remove) i had left over from my AR Drone. The light on the right looks a tad crooked so I’ll need to drill out the hope a bit to level it out.

Thanks for the great write up and wiring help. I grounded to the frame and used a quick-connect to the purple with in my reverse light. Easy pesy lemon squeezy.

 

[Rookie]

Looks good

 

[dataustin]

Great job!

 

[Raptor Embroidery]

What did you use to cut the bumper? I'm about to do this

Sent from my DROID RAZR using Tapatalk 2

 

[Slacker]

What did you use to cut the bumper? I'm about to do this

I used a Dremel with a cut-off disc.

 

[mwaite09]

I needed a grinder anyway so I went to lowes and got one for $40 + 2 cut-off disks...