PSS Power steering reservoir leak?

[m3dragon]

I have tried to contact PSS (Charlie) and I have not gotten a reply so turning to the forums.

I have the full PSS cooling and reservoir kit. I get some leaking from what I am gathering is the vent hole on the top of the reservoir. I am going with this is not normal but I have not gotten a hold of PSS to ask what is going on.

Anyone else have this issue and or have a fix. Fluid should not be coming out of the unit.

 

[svt_reid]

How much fluid is leaking out? Are you driving your truck hard?

 

[Deleted member 12951]

How full do you have it? It should only be filled to the ridge that you see inside. If you overfill it, it will come out the relief valve.

 

[m3dragon]

Driving hard on long trips.

Not a lot but still none should come out in my book

There is still expansion room in the tank. It was not FULL.

 

[Mluis11]

I had the same thing happen on the R2V run. Not a lot, but definitely weeping past the fitting on the cap. It was filled to the fill line. @Trick_Raptor did yours do this?

 

[Trick.Raptor]

I had the same thing happen on the R2V run. Not a lot, but definitely weeping past the fitting on the cap. It was filled to the fill line. @Trick_Raptor did yours do this?

I had a little come out of the vent screw on the cap. Not even enough to make a difference on fluid level but it does make the cap/reservoir and lines greasy which of course the dirt sticks to it making it look much worse than it is.

It's been that way since day one.

 

[Deleted member 12951]

I haven't ran hard with my PSS setup as I recently installed it. Previously I had the RPG one. Their relief valve was on the side with a rubber hose to bring it down further. On runs I would have PS fluid coming out too.