TomDirt
FRF Addict
MAKE IT HARDER TO STEAL. Otherwise all those mods just make it more desirable for the sh itstain who steals cars for a living.Congrats!! The white exterior always looks so clean IMO. What’s your first mods?!
Picked up my 2023 Raptor
- Thread starter ekalb
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Mj1anderson
Active Member
Beautiful truck and welcome to the team!First mod was hardwiring in my radar detector last night
LineX is actually going on the bed tomorrow. That was the one option I really wanted that was missing.
Tonneau cover thats been in my garage for a week will go on after that.
Nothing else planned at the moment
I'd also recommend line-x the rear wheel wells as well!
OP
OP
ekalb
Full Access Member
I tried the Husky liners on my 2018 XLT. I couldn't get them installed and it wasn't for lack of effort. I went with OEM and they were much easier (but more light duty in terms of the thickness of the plastic). How was the husky install on the raptor?
OP
OP
ekalb
Full Access Member
It took a few minutes a side. Zero fitment issues whatsoever.
Husky Liners showed up. The holes aren’t anywhere near the marks on the liners. I guess one is kinda close. Man I went through this same thing with my 2018 and ended up with OEM. I think that’s where this is headed assuming they can be returned. It would be better to have the purchaser drill the holes than someone who doesn’t care about the install.
Attachments
OP
OP
ekalb
Full Access Member
yikes. I would contact whoever you got them from and get the set replaced. I'm not sure there even are OEM ones for these trucks. I could be wrong there though.
Not really worth asking since I can see the photos, I'm sure you noticed they are side specific, right?
Not really worth asking since I can see the photos, I'm sure you noticed they are side specific, right?
calsunraptor
Member
Just installed mine couple of days ago and mine weren't drilled aligned with the markings either but surprisingly installed no problem. I did loosely install those 2 bolts first before tucking the liner in the flare/bed gap. Took about 30 minutes total.
Similar threads
