GEN 2 P0035

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

nikhsub1

FRF Addict
Joined
Mar 5, 2017
Posts
4,316
Reaction score
5,021
Location
Los Angeles
So i just started getting this P0035 code. Anyone know what it is and is there a quick fix?
TIA!

*edit* I should mention I do have a turbosmart BOV, been running it for a few months though with no issue, until now.
 
Last edited:

FordTechOne

FRF Supporting Member
Supporting Member
Joined
Jul 29, 2019
Posts
6,665
Reaction score
13,041
Location
Detroit
Most likely related to your BOV. Do you hear it working?

P0035 - Turbocharger/Supercharger Bypass Valve A Control Circuit High


Description: This DTC sets when the PCM detects an open circuit or high voltage in the TCBY circuit.
Possible Causes:
  • Damaged turbocharger bypass (TCBY) valve
  • TCBY circuit open
  • TCBY circuit short to voltage
Diagnostic Aids: Check the harness for intermittent concerns, incorrect connections, routing, alterations and damage due to contact with other components.


This DTC only sets when the valve is commanded open.
 

digscruze

Full Access Member
Joined
Feb 25, 2020
Posts
77
Reaction score
35
Location
South Fla
P0035 is caused by the BOV. Make sure the crimping tool used is properly crimped Between the OEM cable to avoid the code.

I had the same issue with the connection. However MPT just removed the code from appearing with their tune. However, they confirmed it’s related to the BOV. I have the TS Supersonic BOV.
 
OP
OP
nikhsub1

nikhsub1

FRF Addict
Joined
Mar 5, 2017
Posts
4,316
Reaction score
5,021
Location
Los Angeles
OK thx. I have an email into turbosmart. Was working fine for the last 3-4 months, although I haven't been driving that much since covid...
 

ericburney

Desert is the best medicine
Joined
May 23, 2017
Posts
107
Reaction score
84
Location
Northern Utah
I got one of the first EM BOV. No issues. 30K miles.

Some EM BOVs had issues with the connector clip...if you keep having this happen, contact turnbosmart and they will ask you to send them a photo of their connector to determine the cause. Good luck
 
Top