OEM KO2s Cupping

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

GDK

Active Member
Joined
Dec 5, 2022
Posts
87
Reaction score
70
Location
Charlotte, NC
We also have a Rubicon and you can really pickup any unusual road noises. We switched from KO2's to Nitto's and wish we could have just tried them for one drive instead. They are terrible, seem to be a harder rubber compound and, they are LOUD!
Just my opinion but when you drop the pressure on a KO2 it will climb anything and they ride and sound like a Car tire.
 

LayinWatts69

FRF Supporting Member
Supporting Member
Joined
Sep 20, 2023
Posts
229
Reaction score
558
Location
Las Cruces, NM
Interesting to see you guys are running low 30's for pressure, I dropped mine to 36 and noticed a little difference, I think I'm going to 34.
 

smurfslayer

Be vewwy, vewwy quiet. We’re hunting sasquatch77
Joined
Dec 16, 2016
Posts
17,549
Reaction score
27,021
The latest I’ve heard by way of FRF from Raptor Assault is 32F / 28R. And one of our Jen Too did a chalk test with the tires and found that over 32 psi the tires aren’t making full contact patch, wearing the center faster. MANY of us found this out the hard way. If you run 38/38 like the door placard says, you’ll get great economy, have shít traction and wear the center of the KO2’s at 2x the rate of the edges.

I started dropping PSI after Raptor Assault a little at a time and keep it around 34-35 F, 33-32 rear with cargo and rotate frequently.

Good luck.
 

swoop1156

FRF Addict
Joined
Dec 14, 2010
Posts
3,825
Reaction score
786
Location
USA
The latest I’ve heard by way of FRF from Raptor Assault is 32F / 28R. And one of our Jen Too did a chalk test with the tires and found that over 32 psi the tires aren’t making full contact patch, wearing the center faster. MANY of us found this out the hard way. If you run 38/38 like the door placard says, you’ll get great economy, have shít traction and wear the center of the KO2’s at 2x the rate of the edges.

I started dropping PSI after Raptor Assault a little at a time and keep it around 34-35 F, 33-32 rear with cargo and rotate frequently.

Good luck.
I thought I read somewhere on here that the Raptor Assault instructors stated 38 front and 35 rear when cold. I went to that and things are great. Front usually heat up to around 41 and the rear to 38.
 

smurfslayer

Be vewwy, vewwy quiet. We’re hunting sasquatch77
Joined
Dec 16, 2016
Posts
17,549
Reaction score
27,021
I thought I read somewhere on here that the Raptor Assault instructors stated 38 front and 35 rear when cold. I went to that and things are great. Front usually heat up to around 41 and the rear to 38.
How long have you been running pressure like that? I think after about 7500 miles you should see noticeable difference between center wear and edge wear. Jen Too forums have posts about this, along with the unusual inside / front tire wear.
 

jeanco

2019 scab=gone,24 AMB 801A
Supporting Member
Joined
May 3, 2019
Posts
905
Reaction score
561
Location
OR Beach
run 35-33.just change tire at 37 000.still ok but with rainy season,get very slippery and the ride is better.
Remenber:
One of the major reasons that tires on new cars wear out so fast is how they are produced. Compared with tires that are purchased from specialty tire stores, tires on new cars that come from the factory are fitted with softer rubber. The tires have a slightly better performance by utilizing a softer compound.
 
OP
OP
relak

relak

Full Access Member
Joined
May 12, 2022
Posts
358
Reaction score
486
Location
Northeast
The latest I’ve heard by way of FRF from Raptor Assault is 32F / 28R. And one of our Jen Too did a chalk test with the tires and found that over 32 psi the tires aren’t making full contact patch, wearing the center faster. MANY of us found this out the hard way. If you run 38/38 like the door placard says, you’ll get great economy, have shít traction and wear the center of the KO2’s at 2x the rate of the edges.

I started dropping PSI after Raptor Assault a little at a time and keep it around 34-35 F, 33-32 rear with cargo and rotate frequently.

Good luck.
Wait so running a lower PSI won’t cause cupping? I’m just trying to prevent that from happening again since it made my ride rough at 70-80mph
 

dsiggi

Full Access Member
Joined
Nov 2, 2017
Posts
379
Reaction score
226
Location
Detroit
The Gen3 calls for less camber than Gen 2. I've updated my Gen 2 to the Gen 3 alignment specs and it seems to have helped some. Suprised still having same issue on Gen 3
 
Top