Mixing E Load and C Load K02’s

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Morrisabm

Active Member
Joined
Apr 27, 2019
Posts
70
Reaction score
72
Location
Frisco, TX
Started doing it on my TJ back in 2003-2009 when I lived in CO. No harm in an open differential. 37 was to big to haul on my back door with my setup and the class IV trails I was doing, needed to get my pumpkin a little more off the ground.
Yeah, I wouldn’t do that on your raptor….or any vehicle for that matter. Each axle should have the same size tires and 4wd vehicles should have the same size all the way around. Spend the money up front to get the same size tires all the way around including the spare.

As for different load ratings as long as the rotating diameter is the same I don’t think it would cause any issues.
 

DAVfoto

Full Access Member
Joined
Mar 2, 2021
Posts
263
Reaction score
277
Location
Clifton NJ
I've run different brand spares before but never different sizes. If you get a spare near when buy your main tires, you can rotate the spare in and prolong life of all 5. Not a must but just an option.
 

Badgertits

FRF Addict
Joined
Jan 24, 2019
Posts
2,813
Reaction score
2,450
Location
Ma
Yeah, I wouldn’t do that on your raptor….or any vehicle for that matter. Each axle should have the same size tires and 4wd vehicles should have the same size all the way around. Spend the money up front to get the same size tires all the way around including the spare.

As for different load ratings as long as the rotating diameter is the same I don’t think it would cause any issues.
I mean- it’ll for sure cause handling issues, probably better to keep the rock hard stiff sidewall E load tires in front w/ reduced psi & the softer factory C’s out back….shouldn’t have to explain why lol
 
Top