Icon 3.0 shocks rebuild help Gen 2

[M3sparky]

Hi guys, I haven't found much on these shocks but I wanted to get some assistance or help on anything that can help me get my shocks rebuilt or sent in to get them redone. I have the icon 3.0 coil overs in front with external reservoir, and 3.0 in the rear with reservoir as well. Hoping there is some DIY videos or guides on someone that has done It, or if not perhaps someone near sacramento CA is able to do it would help to.

Ps - my brothers Gen 2 raptor also needs a desperate rebuild he has over 100k on his truck shocks but his are the aftermarket fox 3.0 I believe.

 

[The Car Stereo Company]

i sent you a message

 

[Nex]

Give Hammer a call.

Shocks By Hammer - Huron, SD

 

[M3sparky]

Thanks guys will hit them up and see if the cost and time works out for me.

 

[rngrjcw275]

Give Hammer a call.

Shocks By Hammer - Huron, SD

Unmmmm that sounds like a pornstar reference…, hmmm Clinton’s military era right?

Seriously though, the site is down, could you or someone else send some other options please.

 

[HighwaySentinel]

Shocks By Hammer

www.shocksbyhammer.com

This one works

Unmmmm that sounds like a pornstar reference…, hmmm Clinton’s military era right?

Seriously though, the site is down, could you or someone else send some other options please.

 

[M3sparky]

Shocks By Hammer

www.shocksbyhammer.com

This one works

they have some great pricing, i got mine done for about 900 in NV for the set plus had to drive them about 2 years to deliver each way then pick up when they were done.

 

[kocher93]

I did my Icon 3.0 fronts last year, they weren't too bad. I'm about to crack into my rears before I sell them so they're fresh. If you've done other shocks they're nothing crazy.

 

[rngrjcw275]

I got my gen2 at 54k last year, doing a lot of back and forth to the swamp area and Montana so added 30k to the miles. On my trip back noticed I wasn’t “floating” like I used to, the front seemed to bounce.. similar issue on my wife’s Z4 and it was front shocks.. Wasn’t sure about replacing, rebuilding, or… Appreciate the info, I’ll have to give these folks a holler on rebuilding. I’m just wanting some not have to mess with shocks, which it sounds like the Fox ones you have to dial in..

 

[Kaled]

Hi guys , sorry this may not be related to the Op topic on icon shocks service . I do have Icon 3.0s on my Gen 1 Raptor and had the evil +2 midtravel kit installed . I was wondering is the icon 3.0s or any Oem replacement 3.0s are the way to go with a bolt on midtravel kits on the Gen 1 ? Or is it the incorrect combination /formula ?