Harvey Eng's 2014 700+HP Raptor by JDM

[JimIII@JDM]

We just finished installation of another one of the JDM 700 HP Whipple Supercharger packages on Harvey Eng's 2013 Raptor F-150! Harvey dropped his truck off last week for the upgrade along with a few other goodies! We installed Kooks custom headers and Y pipe with Green cats to his Magnaflow catback. Also a set of Deaver leaf springs to help stiffen up the rear and provide more traction with the extra power! A 1 piece aluminum driveshaft from Axle Exchange to ensure he doesn't leave his stock one on the road with over 650 lb/ft of Torque! We installed an Autometer boost/vacuum gauge for a little interior dress up. Last but not least we set the front shocks to mid perch to give him a nice level stance. I'll be back Friday with a dyno graph when Jim Sr. gets back in town from Texas. After custom tuning this truck should make around 550 RWHP which equates to roughly 700-725 HP through this monster drivetrain.

JimIII

 

[tahitiansoul]

Me want this so far.

 

[Wizechef]

 

[69Mach1]

Very nice!

 

[oplersx]

Nice!!!!!!!!!!!!!!

 

[cpetes]

Great setup. I really like a stock form truck that packs a punch!

 

[Big Bill]

JDM 700 HP Whipple Supercharger I'll be back Friday with a dyno graph when Jim Sr. gets back in town from Texas. After custom tuning this truck should make around 550 RWHP which equates to roughly 700-725 HP through this monster drivetrain.

JimIII
QUOTE]

Another great job by JDM Wow 550 RWHP.
Looking forward to Friday to see the Dyno Graph and hear how the custom tune goes. I'll be waiting patiently.
Bill

 

[JimIII@JDM]

JDM 700 HP Whipple Supercharger I'll be back Friday with a dyno graph when Jim Sr. gets back in town from Texas. After custom tuning this truck should make around 550 RWHP which equates to roughly 700-725 HP through this monster drivetrain.

JimIII
QUOTE]

Another great job by JDM Wow 550 RWHP.
Looking forward to Friday to see the Dyno Graph and hear how the custom tune goes. I'll be waiting patiently.
Bill

Thanks Bill, Sr. pushed back his flight again and we are stuck with out him until Monday now. So when he gets back next week we will dyno it and see where it's at for power.

 

[MILRTME]

How much power will that drive shaft handle?

 

[JimIII@JDM]

How much power will that drive shaft handle?

A similarly spec'd shaft in our Cobra Jet's handles 1500 HP and low 8 sec 1/4 mile et's. Same component quality and design work goes into these shafts!

JimIII