Gun holders

[JetDriver480]

The MPX often comes with a folding Arm Brace. I SBR'd mine with a Sig Telescoping Stock to make it smaller than an MP5... My barrel was cut to 4.5"

...My buddy has a belt fed in his truck in Arizona lol. Best laws in the union here... also don't hear about car jackings in Arizona often but then again I live in Scottsdale where there are more Raptors than lowered Impalas if you know what i mean.

 

[Azholley]

The MPX often comes with a folding Arm Brace. I SBR'd mine with a Sig Telescoping Stock to make it smaller than an MP5... My barrel was cut to 4.5"

...My buddy has a belt fed in his truck in Arizona lol. Best laws in the union here... also don't hear about car jackings in Arizona often but then again I live in Scottsdale where there are more Raptors than lowered Impalas if you know what i mean.

Sent from my iPhone using Tapatalk

 

[Khilborn]

And Mississippi, your vehicle is considered an extension of your home.


Sent from my iPhone using Tapatalk

Florida is the same, considered your domicile.

 

[Uzzirider]

The MPX often comes with a folding Arm Brace

"Folding Arm Brace" should always be used in quotes.

AZ had the best gun laws. Was one of the initial reasons I looked to move here.

 

[JetDriver480]

Can't beat it... my buddy has a 50 cal mounted to his RZR and drove it to Costco... got pulled over cause the cop wanted to see if he could shoot it lol.

 

[Uzzirider]

the cop wanted to see if he could shoot it

At $3-4 per round, probably not!
I've always dreamed of putting an M2 on the roof of my H1, but then it wouldn't fit in my garage. #AZproblems

 

[Azholley]

A pick will probably answer this question, but, how do you get a secure grip for the draw with this setup? Every one of these I have seen so far has the grip sitting below the top of the console.

Smurf I just finished my kydex OWB carbon fiber holster last night. If you notice I trimmed down the grip area and also molded the back side higher than the front to prevent unnecessary rubbing and for me to be able to draw quickly. I will be making the same holster for the truck to be mounted without the bend points. Hope this makes sense. There's obviously a lot more to this process but just wanted to show a couple pics for you guys.

Sent from my iPhone using Tapatalk

 

[smurfslayer]

I would bet that with a straight profile, you could craft an attach point to the lip on the center console and that would make accessibility quite good.

 

[Azholley]

I would bet that with a straight profile, you could craft an attach point to the lip on the center console and that would make accessibility quite good.

Yes sir that's what I've been thinking but I need a damn truck to see what I'm working with lol 1 more week of stir crazy.


Sent from my iPhone using Tapatalk

 

[JetDriver480]

Make me one!