Group Buy-Bullet style antenna from CravenSpeed

[BLACKMAMBA777]

You can place a pre-order here.

---------- Post added at 10:06 AM ---------- Previous post was at 10:05 AM ----------



6061 aluminum. Here is a shot of the design:

Pre-ordered!

 

[Kellen@Craven]

That's 31

 

[Devilsfan72]

Ordered

 

[NickPic83]

I need a good measurement on the top of the base where the stubby goes in from one of you guys. Who has calipers? We might need to scale down the 50 cal just a bit to make it look right.

Can anyone help Kellen out with this?

Sent from my XT1080 using Tapatalk

 

[iown1]

Ordered 1

---------- Post added at 12:49 PM ---------- Previous post was at 12:48 PM ----------

I can when my truck gets back. Let the wife take it today

 

[blockdoc]

I have calipers; I'm just not sure what needs to be measured. I'll be happy to do it

 

[oilman]

Ordered mine today

 

[NickPic83]

Ordered 1

---------- Post added at 12:49 PM ---------- Previous post was at 12:48 PM ----------

I can when my truck gets back. Let the wife take it today

I have calipers; I'm just not sure what needs to be measured. I'll be happy to do it

There u go Kellen u got 2 helpful members there...

Thanks guys!

Sent from my XT1080 using Tapatalk

 

[Kellen@Craven]

Looking for the diameter of the flat area on the top of this base. Our Original design is about 1/2 inch which would require us to scale the .50 cal down to about the same height as the Stubby. So, we want to know how big the base should be so that these things look right when they are installed.

-=Kellen

 

[ZakGSXR]

I can take the dimensions and have them to you in a few minutes if still needed...