GooseTuned Gen 3 - Baseline Dyno Runs vs Gen 2 Baseline!

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

OP
OP
GooseTuned

GooseTuned

Supporting Vendor
Supporting Vendor
Joined
Aug 24, 2018
Posts
1,610
Reaction score
1,906
Location
New Mexico
That was my first thought... When I work on plastic items, I either heat them up with a heat gun if it is below 60, or bring it in the garage and let it get to temp (my garage is heated).
Gotcha!

My truck was driven right before removal so it was warm.

Heating it up may not be a bad idea
 

GLT

Full Access Member
Joined
Sep 28, 2016
Posts
154
Reaction score
107
Location
DFW
Gotcha!

My truck was driven right before removal so it was warm.

Heating it up may not be a bad idea

Well, it was 85 degrees in Dallas yesterday, and I had just driven my truck when I removed the ECU, and still broke the tab on the bottom right. Messed with it for 20 min trying to get it to unclip, and it finally broke on me.
 

Idaho Savage

FRF Supporting Member
Supporting Member
Joined
Jan 26, 2022
Posts
118
Reaction score
212
Location
USA
Any reason I can't install the Cobb intercooler, wait a week, then do the ECU portion? In other words, the Cobb IC won't cause problems by itself, correct? I can't see how it would but I thought I'd ask, as it's being installed Tuesday.
 

10SpdsOfFury

FRF Supporting Member
Supporting Member
Joined
Jul 16, 2017
Posts
2,607
Reaction score
11,408
Location
Jacksonville FL
Any reason I can't install the Cobb intercooler, wait a week, then do the ECU portion? In other words, the Cobb IC won't cause problems by itself, correct? I can't see how it would but I thought I'd ask, as it's being installed Tuesday.
Nope not at all, have at it.
 
Top