Gen3 Mexican Uboat commander

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

CodeOrangeGen3

Active Member
Joined
May 13, 2021
Posts
99
Reaction score
71
Location
Austin, TX
As I commented on YouTube….dumb move, but damn impressive (esp considering moving current)

I’ve watched this video probably 20 times across different posts. With water that high over the hood how does it not get into the intake? Is there a drain somewhere to help with this? I hit a fat mud puddle last week and it covered the engine with mud. After that I probably wouldn’t have the balls to attempt a crossing like this. Looks fun though!!!
 

Attachments

  • BD62B102-0AA6-486B-A573-510CEFD63A6B.jpeg
    BD62B102-0AA6-486B-A573-510CEFD63A6B.jpeg
    250 KB · Views: 39
  • 22798347-BA9A-43AC-BDBC-E41F2AE0D713.jpeg
    22798347-BA9A-43AC-BDBC-E41F2AE0D713.jpeg
    268.3 KB · Views: 37

AutoXRacer

Full Access Member
Joined
Oct 28, 2021
Posts
293
Reaction score
215
Location
Florida
What people don't take into consideration is the driveline... sure worry about ingesting water through the intake, but the transmission and rear axle are not water tight... water gets in through breather tubes, sometimes axle seals, and engine PVC connections...a factory vehicle is not prepared / equipped for water crossings.

After a crossing like that you need to drain all fluids to remove any water.
 

AxelR

Full Access Member
Joined
Aug 9, 2021
Posts
300
Reaction score
313
Location
Sunset
I’ve watched this video probably 20 times across different posts. With water that high over the hood how does it not get into the intake? Is there a drain somewhere to help with this? I hit a fat mud puddle last week and it covered the engine with mud. After that I probably wouldn’t have the balls to attempt a crossing like this. Looks fun though!!!
Maybe that way you could clean your engine
 

AxelR

Full Access Member
Joined
Aug 9, 2021
Posts
300
Reaction score
313
Location
Sunset
What people don't take into consideration is the driveline... sure worry about ingesting water through the intake, but the transmission and rear axle are not water tight... water gets in through breather tubes, sometimes axle seals, and engine PVC connections...a factory vehicle is not prepared / equipped for water crossings.

After a crossing like that you need to drain all fluids to remove any water.
… I don’t know about the Raptor, probably should look into it, but Land Rover and others are actually ready from the factory for water. The main water deity limitation coming from ECUs and other electronic components that are often located under the front seats…
Obviously this looks a little excessive but he’s got warranty after all.
 

AutoXRacer

Full Access Member
Joined
Oct 28, 2021
Posts
293
Reaction score
215
Location
Florida
… I don’t know about the Raptor, probably should look into it, but Land Rover and others are actually ready from the factory for water. The main water deity limitation coming from ECUs and other electronic components that are often located under the front seats…
Obviously this looks a little excessive but he’s got warranty after all.
You think Ford would cover a vehicle used outside normal use?

I don't think Ford would cover it...

I've seen Jeep revoke warranty due to hydrolock and or water found in the driveline.
 

JasonSTL

Full Access Member
Joined
Dec 14, 2019
Posts
271
Reaction score
273
Location
St. Louis, MO
I think our Raptors can ford 32” of water if I remember correctly. Looks like he was in water shallower than the tires so I think he’s ok. I wouldn’t do it, but don’t think he hurt anything.
 
Top